Defective water column in the new dress Material: * water column
* CreaPop film
* fleece (2 m)
* napkins adhesive
* artificial boxwood garland (about 2 m)
* lights
* ribbon
* cotton balls
* green acrylic paint
* silver-colored cord
* Hot glue gun
* Brush
* scissors
* Tacker
Here's how:
The cap from the top of the water column and the column Brush with napkin glue, omitting the foot.
start The fleece top oblique and spiral along the column fit smoothly down on the glass.
Below the fleece trimming precisely the base form accordingly.
Brush with napkins glue the overlapping edge again, as fleece is on fleece, and dry well. Attach
with a hot glue gun along the fabric edge of the artificial boxwood. Here is always a bit of stick after the other, as the book tree is still very stubborn.
the rests of the web cut above the margin.
Now drill into the column from the bottom hole, so that by the lights fit the lights.
Tip: a thread at the lights fixed nodes, so that the pulling works better.
The lights now move first through the hole at the base (here usually runs the power cable).
then pull through the bottom of the column up with the thread.
be on the top edge, two bulbs hanging over the edge.
Now put the lid of the column again. From
CreaPop film 2 small semi-circles cut out and paste also with fleece.
These bags around the individual Festtackern lights and shapes, so that they can not slip. bind
from ribbon loop and secure with double sided tape on the lights.
paint four green cotton balls, pull a silver cord, tie it down and put up on the column.